KiwiPollen Duster Operating Instructions

Assembly of Dispenser Unit

• Screw the reservoir bottle into the dispenser, approximately one turn until a snug fit is obtained. Fit tube to blower motor as per factory instructions.
• A straight and a curved delivery tube have been supplied. The short straight nozzle gives a wider spread of pollen while the long curved nozzle gives a narrower distribution.

Operation of the Duster

• The pollen dispenser has a variable speed controller with three marked settings (Lo -Medium - Hi):
• Pure pollen should be applied at the "Lo" to "Med" position.
• 50:50 pollen mix should be applied in the "Medium" to "Hi" position.
• Follow the blower manufacturer instructions for starting and general operation.
• After use, clean the dispenser by removing the jar and with the electric motor running, clean out the residue pollen with a vacuum cleaner or compressed air.

Start Up Procedure

• Start up the blower and warm up the motor.
• Put battery pack on shoulder and blower unit on opposite shoulder.
• Plug in the power plug to the socket at the back end of dispenser, this can only fit one way.

Battery Maintenance

• The 12 volt battery supplied is of ample capacity to give a full days operation.
• Recharge the battery over night with the charger provided. Battery should be charged 3 times during the year when not in use.

For further Technical Information contact Kiwi Pollen

Copyright © 2011 - 2012 Kiwi Pollen, New Zealand. All rights reserved

Sitemap | Privacy | Site by MOCA