Mixer Operating Instructions

PollenAid® Mixer Operating Instructions:

• There are two impellors supplied with the mixer.
  • The small white impellor is for mixing 5 litres or less of liquid.
  • The large black impellor is for mixing 5-10 litres of liquid.
• The small impellor is attached ready for use. The large impellor is attached underneath the base near the motor. This can be removed and swapped with the small impellor when necessary.
• The impellor can be attached by pushing on to the motor shaft, until the shaft is flush with the top of the impellor. Attach the large black impellor with the holes to the top. Attach the white impellor with the flat side down.
• Connect a 12 volt battery with the red battery lead to the positive terminal and the black lead to the negative battery terminal.
• Add the PollenAid®® and Marker Dye to the deionised water first. Then add the pollen. Mix for 10 minutes or until the pollen is in suspension, that is, there is no pollen left floating on the top of the mix.
• Use the mix within one hour.

For further Technical Information contact Kiwi Pollen
 

Copyright © 2011 - 2012 Kiwi Pollen, New Zealand. All rights reserved

Sitemap | Privacy | Site by MOCA